Guest Guide

Hot Spring Limelight Pulse Hot Tub

Guest-safe instructions for using the Hot Spring Limelight Pulse hot tub and Smartop Vanish XL cover at Perch in the Clouds.

Outdoor deckGuestHot Spring Limelight Collection PULSE with Smartop Vanish XL coveromluxeproperties.com/how-to/hot-tub

Video

Before opening, check that the water looks clear, the deck and steps are safe, and there are no flashing Ready, Power, logo, or warning lights.
Do not use the hot tub during lightning, severe weather, or high wind.
Keep glass, food, drinks, soap, oils, lotions, bubble bath, and bath bombs away from the water.
To open the Smartop cover, release the latches or cam locks with fingers clear of pinch points.
Fold the first half of the cover over the second half, grip the EAS handle, and guide the cover into the open position behind the spa.
Do not force, drop, sit on, stand on, or place luggage/items on the cover.
Wake the control panel and check current temperature and set temperature before entering.
Normal guest comfort is usually 100-102F; do not enter if the water is above 104F.
If the Ready light is off or the water is not warm yet, close the cover and allow warming time.
Use Jets to turn massage on and off; rotate adjustable jet faces gently by hand to change pressure or direction.
Use the air or ComfortControl knobs to make the jet feel stronger or softer.
Use Lights as needed, and turn the waterfall off before closing the cover.
After use, turn off jets, lights, and waterfall, then remove towels, cups, toys, and personal items from the water and deck.
Grip the EAS handle, guide the Smartop cover back over the spa, unfold it flat, check that it seals evenly, and secure the latches.

Water is cloudy, foamy, smelly, dirty, or unusually hot
1. Do not enter the hot tub.
2. Close and latch the cover.
3. Contact your host with a photo of the water and control panel if safe.
Ready, Power, logo, or warning lights are flashing
1. Stop using the hot tub.
2. Close and latch the cover.
3. Contact your host before anyone enters.
Water is not warm yet
1. Confirm the cover is closed and latched when nobody is using the hot tub.
2. Keep jets, lights, and waterfall off while the spa warms.
3. Allow warming time; hot tubs do not recover instantly after the cover has been open.
4. Contact your host if the Ready light stays off or the water does not recover.
Jets are weak, surging, or not flowing normally
1. Turn jets off once and back on once.
2. Make sure no towels, toys, or cups are near suction/filter areas.
3. Do not remove filters or open panels.
4. Stop use and contact your host if flow still feels weak or surging.
Smartop cover is hard to move, will not latch, or looks damaged
1. Do not force the cover.
2. Keep fingers clear of hinges and pinch points.
3. Contact your host if the cover does not move smoothly, seal evenly, or latch.